Ositech comm 614006-001 - Manual (Page 45)

User’s Guide and Reference 4 - 3
Appendices
Note: This keyword is used to disable the Link Test Function on a 10BaseT
network connection only.
INT <interrupt level>
Description: Set the interrupt level
Default: 5 or AUTO
Accepted values: Any valid interrupt value excluding 0, 1, 2, 6, 8, and 13
Note: If this keyword exists, the driver will return an error when unable to
operate using the specified interrupt. If the keyword does not exist, the
default interrupt level will be 5 if Card Services is not present;
otherwise, the first available interrupt obtained from Card Services will
be used.
MEM <memory location>
Description: Maps to 4K host memory location
Default: C8000
Note: When Card Services is not present (the only scenario in which this
keyword applies), the Trumpcard driver will require the 4K memory
window in order to determine the Trumpcard’s presence. If running a
memory manager (such as EMM386 or QEMM), make sure to exclude
the memory range used, i.e. X=C800-C8FF
PORT <I/O port>
Description: Set the I/O port
Default: 300 or AUTO
Accepted values: Any location within a 64 byte boundary (300 and up in
increments of 40, with the upper limit dictated by the individual machine)
Note: If this keyword exists, the driver will return an error if unable to operate
using the I/O port specified. If the keyword does not exist, the default I/
O port will be 300 if Card Services is not present; otherwise, the first
available I/O port obtained from Card Services will be used.
NODE ADDRESS <nnnnnnnnnnnn>
Description: Station address used to override the default PROM value.
Default: None (driver uses PROM)
Accepted values: Valid hexadecimal for a Station Address according to
Ethernet pattern.