Ositech comm 614006-001 - Manual (Page 39)

User’s Guide and Reference 3 - 19
Operation
Loading the OS/2 ODI Driver
The OS/2 ODI driver OTCETH.SYS for the Trumpcard is an OS/2 device
driver, it must
always be loaded after the LSL (Link Support Layer)
module and before the IPX (IPX Protocol Stack).
Below is an example of a possible CONFIG.SYS file which allows the
loading of necessary modules to establish a link from an OS/2 Workstation
to a Netware Server:
REM --- Netware Requester statements BEGIN ---
DEVICE=C:\NETWARE\LSL.SYS
RUN=C:\NETWARE\DDAEMON.EXE
DEVICE=C:\NETWARE\OTCETH.SYS
DEVICE=C:\NETWARE\IPX.SYS
rem DEVICE=C:\NETWARE\SPX.SYS
rem RUN=C:\NETWARE\SPDAEMON.EXE
rem DEVICE=C:\NETWARE\NMPIPE.SYS
rem DEVICE=C:\NETWARE\NPSERVER.SYS
rem RUN=C:\NETWARE\NPDAEMON.EXE NP_COMPUTERNAME
DEVICE=C:\NETWARE\NWREQ.SYS
IFS=C:\NETWARE\NWIFS.IFS
RUN=C:\NETWARE\NWDAEMON.EXE
rem DEVICE=C:\NETWARE\NETBIOS.SYS
rem RUN=C:\NETWARE\NBDAEMON.EXE
rem DEVICE=C:\NETWARE\VIPX.SYS
rem DEVICE=C:\NETWARE\VSHELL.SYS
REM --- Netware Requester statements END ---
Note: If your Ethernet frame type is NOT 802.2, you must use the NET.CFG
file to supply the appropriate frame type. The OTCETH driver will
default to 802.2 in accordance with Novell's specifications.
Note: Keyword specifications associated with the ODI driver are explained in
Appendix A, Error Messages in Appendix C.
Novell Unixware DLPI Driver
The Trumpcard DLPI Driver is an AT&T Data Link Provider Interface
(DLPI) compliant loadable STREAMS driver, for UNIX System V Release
4.2. The driver has a built in enabler for Intel, Databook and compatible
PCMCIA equipped computers. With this driver installed networking
functions will be available under Unixware.