Ositech comm 614006-001 - Manual (Page 9)

User’s Guide and Reference 2 - 1
Hardware Installation
Section Two
Hardware Installation
Unpack the Trumpcard Ethernet LAN hardware, and follow the steps
listed below to install it on your computer. Instructions are included for
both 10BaseT twisted-pair and 10Base2 thin coax Ethernet Network
operations.
Preparing for Installation
To install the Trumpcard, you require the accompanying diskettes and the
following items:
• A computer equipped with a PCMCIA Release 2.0, Type II PC
Card slot.
• PCMCIA Card and Socket Services Version 2.x or higher,
installed. This is optional since the Trumpcard can be operated
without Card and Socket Services.
• A Network operating system that is supported by the Trumpcard
Network drivers.
• For 10Base2 (thin coax) Networks, a coaxial T-connector and a
terminator if at the end of the coaxial segment.
• For 10BaseT (twisted pair) Networks, a twisted pair Network cable
terminated with an RJ-45 connector when using the Media Access
Module for 10BaseT connections.