Omron ETHERNET DIRECT DR 170 14 - Manual (Page 59)

Klinkmann Automation Omron Ethernet DAServer 57
Omron Ethernet DAServer Ver 1.x User Manual Rev 1.4 17014m14
value from 0
to 65535.
< Socket_
ControllerName>:
Invalid Watchdog
Address
<InvalWdAddress> -
must be valid Item
name. Do not
process Watchdog. Failed creation
of Watchdog
message.
Watchdog
message is not
processed until
solving the
problems.
Invalid Watchdog
Address
configured. Enter right
Watchdog
Address (right
Item name
representing
2-bytes long
Word
memory area
without
suffix). Error
HASP key not found! DAServer does
not find the
valid HASP key
installed No/invalid HASP
key Install valid
HASP key
into parallel
or USB port DASProtWarn
HASP key not found,
demo mode, will quit
after 1 hour! DAServer does
not find valid
HASP key
installed.
Server will run
1 hour in demo
mode. No/invalid HASP
key installed Install valid
HASP key
into parallel
or USB port
or restart
Server after
1-hour demo
expires. DASProtWarn
HASP key not found! DAServer does
not find valid
HASP key
installed. If
demo mode
has been
started, the
Server stops
communicate. No/invalid HASP
key installed Install valid
HASP key
into parallel
or USB port DASProtWarn
Socket <SockName>:
Message with service
ID <number> not
found. Received
response
message with
Service ID, that
does not match
with any of sent
request
messages ID. Problems in
Ethernet FA
network or
communication
timing problems. Configure
greater
communic.
(reply) time-
outs. Check
the network. DASProtFail
<Socket_
ControllerName>:
Invalid item name
<Invalid_ItemName> The item name
is invalid. Item name does
not correspond to
Item naming
conventions for
OMRON Ethernet
DAServer. Use right Item
name (see
Item Names
section in this
manual) DASProtFail
<Socket_
ControllerName>:
Read message for Length of read
message for
Item (or length Usually there
shouldn’t be any
problems creating Configure
satisfactory
max read DASProtFail