Tally Genicom MATRIX PRINTER 2250 - Manual (Page 27)

➤ Messages in the LC
display If the printer detects an internal fault or user error or if it expects you to
do something, a message will appear in the LC display. Below you will
find a list of messages with brief descriptions of each message. The
messages are described in greater detail in the chapter
Troubleshooting .
BACK QUIT
?
PRINT
Reference manual The control panel
17
Message Meaning
Eject error The printer cannot eject paper/advance it to park position.
Hardware Alarm Internal hardware error.
Head hot The printer reports that the print head is hot and that print speed will be
reduced.
Initializing This message appears during the printer’s initializing phase.
Load error The printer cannot draw in the loaded paper.
Loading default Factory defined parameters will be reloaded in all available menues.
Load paper from The printer has no paper in the active paperway.
Parity error A parity error during data transmission is indicated.
Park position Printer was switched on with no paper in print position.
Press any key The user is requested to press any key.
Selftest After power-on, the printer executes a short hardware self-test.
Tear Paper off The user is requested to tear off paper which has been advanced to the
quick tear edge.