Tally Genicom MATRIX PRINTER 2250 - Manual (Page 68)

Parameter group Parameter Description
Special
ErrMode
Blockend
Remote
Handthr
ErrMode = On
ErrMode = Off*
Blockend = On
Blockend = Off*
Remote = On
Remote = Off*
Handthr = On
Handthr = Off*
Can only be selected if the serial interface is installed and if the ENQ/STX,
ETX/ACK or ACK/NAK protocol is set. See Chapter
Interfaces
Error handling; On replaces the incorrect character with ?, Off deletes the
entire block.
End-of-block character definition: On = LF, FF, CR, VT, ETX, DEL, Off =
ETX, DEL.
Signal feedback; On = RDY/BUSY available, Off = No RDY/BUSY control.
Affects the transparence of control sequences and block acknowledgement,
depending on the selected protocol.
Protocol XON/XOFF*
Robust XON/XOFF
ENQ/STX
ETX/ACK
ACK/NAK Selects the protocol for data transmission; see Chapter Interfaces
DTR DTR = DTR*
DTR = READY DTR signal is assigned to DTR line.
READY signal is assigned to DTR line.
DTR = Pin 20 on 25-pin female V.24 connector.
DTR = Pin 4 on 9-pin female V.24 connector.
Interf. Interf.= Share*
Interf. = Parallel
Interf. = Serial Selects the interface. Printer is configured either for parallel or serial con-
nection or in automatic change for both.
BACK QUIT
?
PRINT
Reference manual The Menu
58