Toshiba DeviceNet Option DEV002Z-1 - Manual (Page 15)

E6581281 f
- 14 -
3.4.5.2. Instance 21/71 - DeviceNet Standard (4 bytes, parameter f830 = 1)
Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
0 - Net Ref * Net Ctrl * - - Fault reset
Run
reverse
Run
forward
1 -
2 Drive Reference Speed min -1 (Low byte)
3 Drive Reference Speed min -1 (High byte)
Fig. 3 Output Instance 21 Layout
Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
0
At
reference **
Ref from
Net **
Ctrl from
Net **
Ready
Running
Reverse Running
Forward
Warning
Faulted/
tripped
1 Drive Status ***
2 Drive Reference Speed min -1 (Low byte)
3 Drive Reference Speed min -1 (High byte)
Fig. 4 Input Instance 71 Layout
* Bit 5 and 6 of the instance 21 byte 0 are defined as follows.
Bit 5 (Net Ctrl)................. When “1” is set, bits 0 (Run forward) and 1 (Run reverse) of byte 0 are enabled.
When “0” is set, Run/Stop is according to setup of the parameter cmod.
Bit 6 (Net Ref)................. When “1” is set, bytes 2 and 3 are enabled. When “0” is set, Drive Reference
Speed is according to setup of the parameter fmod.
** Bit 5, 6, and 7 of the instance 71 byte 0 are defined as follows.
Bit 5 (Ctrl from Net)......... When RUN/STOP command from DeviceNet is enabled, “1” is set.
Bit 6 (Ref from Net)......... When frequency command from DeviceNet is enabled, “1” is set.
Bit 7 (At reference) ......... When output frequency becomes the same as frequency command, “1” is set.
*** Drive Status is same as the Control Supervisor class State attribute (refer to section 3.7.2).
1 (= BN: 00000001): Startup
2 (= BN: 00000010): Not Ready
3 (= BN: 00000011): Ready
4 (= BN: 00000100): Enabled
5 (= BN: 00000101): Stopping
6 (= BN: 00000110): Fault Stop
7 (= BN: 00000111): Faulted