Technicolor - Thomson HP 270 - Manual (Page 28)

EN
27
SNAP MODE –
FUL L
MUL T I – 4
MUL T I – 9
P I N–UP
FRAME
D.S.C. RECORDING
Basic Shooting (Snapshot)
You can use your camcorder as a Digital Still Camera for
taking snapshots.
NOTE:
You should already have performed the procedures listed
below. If not, do so before continuing.
● Power ( ੬ pg. 9)
● Viewfinder Adjustment ( ੬ pg. 11)
● Loading A Memory Card ( ੬ pg. 15)
● Picture Quality/Image Size Mode Setting ( ੬ pg. 16)
SNAPSHOT MODE SELECTION
1 Slide down the lens cover while pressing down the
Lock Button located on the cover. Set the VIDEO/
MEMORY Switch to “MEMORY”, then set the Power
Switch to “
” while pressing down the Lock Button
located on the switch. Open the LCD monitor fully
or pull out the viewfinder fully.
2 Press MENU. The Menu Screen appears.
3 Press + or – to select “ CAMERA”, then press SET/
SELECT. The CAMERA Menu appears.
4 Press + or – to select “SNAP MODE”, then press
SET/SELECT.
5 Press + or – to select the desired Snapshot mode,
then press SET/SELECT. Press + or – to select
“ RETURN” and press SET/SELECT twice. The
Menu Screen closes.
SNAPSHOT RECORDING
1 Press SNAPSHOT. appears while the snapshot
is being taken.
The image is stored in the memory card.
•Regardless of the Power Switch position (“
” or
“ ”), Snapshot recording takes place using the
selected Snapshot mode.
Power Switch
SNAPSHOT Button
Lock Button
VIDEO/MEMORY
Switch
F I NE
1 0 / 10 0
VGA
Number of shots taken
Displays the number of images that have already been shot.
Total number of shots
Displays the approximate total number of shots that can be stored, including
those already taken. The number increases or decreases depending on the shots
stored, the Picture Quality/Image Size mode, etc.
Picture Quality mode
Displays the Picture Quality mode of the stored image. There are 2 modes
available: FINE and STD (Standard) (
੬ pg. 16).
Display
Shooting icon
Appears and blinks during shooting.
Card icon
Appears during shooting and blinks when a memory card is not loaded.
Display
CAMERA Menu
Image Size mode
Displays the Image Size mode of the stored
image. There are 2 modes available: XGA and
VGA (
੬ pg. 16).