Technicolor - Thomson HP 270 - Manual (Page 79)

78
EN
SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION
18. The Picture Wipe and
Dissolve functions do not
work.
19. The picture wipe function
does not work.
20. Scene transition does not go
as expected.
21. The Video Echo mode does
not work.
18. • The last selected editing scene
is ending.
• At the end of the last selected
scene for editing, the Power
Switch was set to “OFF”.
• The power is off.
19. • The Slow Shutter mode is
activated.
• “WIDE MODE” is not set to
“OFF”.
20. • When using “Picture Wipe/
Dissolve” ( ੬ pg. 49), there is
a delay of a fraction of a
second between the previous
record stop-point and the
Dissolve start-point. This is
normal, but this slight delay
becomes especially
noticeable when shooting
fast-moving subject or during
rapid panning.
21. • The Picture Wipe or
Dissolve functions are in use.
• “WIDE MODE” is set to
“SQUEEZE ” in the Menu
Screen.
• A Fade-In or Fade-Out is in
progress.
18. • Select Picture Wipe or
Dissolve before beginning
recording. The effects are then
automatically activated
(
੬ pg. 49).
• Do not turn off the
camcorder’s power after
setting Edit-In and Edit-Out
points, as they will all be
erased (
੬ pg. 49).
• The camcorder automatically
shuts off after 5 minutes have
elapsed in the Record-Standby
mode. Make sure you
continue operations within
5 minutes after engaging
Record-Standby mode
(
੬ pg. 49).
19. • Disengage the Slow Shutter
mode or set “WIDE MODE”
to “OFF” before preparing to
use the Picture Wipe
(
੬ pg. 41, 47, 49).
20.
————
21. • Set “WIDE MODE” to
“CINEMA ” or “OFF”
mode ( ੬ pg. 41).
• Do not try to use the Video
Echo mode during a Fade-In
or Fade-Out (
੬ pg. 47, 49).
TROUBLESHOOTING (cont.)