Technicolor - Thomson HP 270 - Manual (Page 59)

58
EN
DUBBING (cont.)
DV cable
(optional)
Video unit
equipped with DV
connector To DV IN/OUT
To DV
Core filter
Dubbing To Or From A Video Unit Equipped
With A DV Connector (Digital Dubbing)
It is also possible to copy recorded scenes from the
camcorder onto another video unit equipped with a DV
connector. Since a digital signal is sent, there is little if
any image or sound deterioration.
[To use this camcorder as a player]
1 Make sure all units are turned off. Connect the
camcorder to a video unit equipped with a DV input
connector using a DV cable as shown in the
illustration.
2 Set the VIDEO/MEMORY Switch to “VIDEO”, set
the camcorder’s Power Switch to “
” while
pressing down the Lock Button located on the
switch, turn on the video unit’s power, and insert the
appropriate cassettes in the camcorder and the
video unit.
3 Press 4/6 to play back the source tape.
4 While watching the playback on the monitor,
engage the DV connector-equipped video unit’s
record mode from the spot on the source tape you
want to begin recording.
To Use This Camcorder As A Recorder . . .
1. Set the VIDEO/MEMORY Switch to “VIDEO”, then set the Power Switch to “ ” while pressing
down the Lock Button located on the switch.
2. Set “REC MODE” to “SP” or “LP” in the Menu Screen ( ੬ pg. 43).
3. Connect the DV cable as shown in the illustration and load a cassette to record on.
4. Press the START/STOP button on the remote control to engage the Record-Pause mode. “
DV. IN ”
appears on the screen.
5. Press the START/STOP button on the remote control to start recording. rotates.
6. Press the START/STOP button on the remote control again to engage the Record-Pause mode. stops
rotating.
NOTES:
● Digital Dubbing is performed in the sound mode recorded on the original tape, regardless of the
current “SOUND MODE” setting (
੬ pg. 40).
● During Digital Dubbing, no signals are output from the AV output connector.
NOTES:
● It is recommended to use the AC Power Adapter/Charger as the power supply instead of the battery
pack (
੬ pg. 10).
● If the remote control is used when both the player and recorder are THOMSON video units, both units
will perform the same operation. To prevent this from happening, press the buttons on both units.
● If a blank portion or disturbed image is played back on the player during dubbing, the dubbing may stop
so that an unusual image is not dubbed.
● Even though the DV cable is connected correctly, sometimes the image may not appear in step 4. If this
occurs, turn off the power and make connections again.
● If “Playback Zoom” ( ੬ pg. 63), “Playback Special Effects” ( ੬ pg. 64) or “Snapshot” is attempted during
playback, only the original playback image recorded on the tape is output from the DV connector.
● When using a DV cable, be sure it has a core filter attached. The core filter reduces interference.
Open the
connector cover.