Technicolor - Thomson HP 270 - Manual (Page 73)

72
EN
R.A.EDIT
ON/OFF
1
2
3
4
5
6
7
8
– – : – – ~
~
~
~
~
~
~
~
– –
N I OUT MODE
RO SYNCH O . 1 –
– – : – –
0 : 00 0 TOTAL
CODE T I ME
For More Accurate Editing
Some VCRs make the transition from Record-Pause to
Record mode faster than others. Even if you begin editing
for the camcorder and the VCR at exactly the same time,
you may lose scenes you wanted, or find that you have
recorded scenes you did not want. For a cleanly edited
tape, confirm and adjust the timing of the camcorder
against your VCR.
DIAGNOSING VCR/CAMCORDER TIMING
1 Play back the tape in the camcorder, then point the
remote control at the camcorder’s remote sensor
and press R.A.EDIT ON/OFF.
Random Assemble Editing Menu appears.
2 Perform Random Assemble Editing on Program 1
only. In order to check VCR and camcorder timing,
select the beginning of a scene transition as your
Edit-In point.
3 Play back the dubbed scene.
•If any images from the scene prior to the
transition you chose for your Edit-In point were
recorded, that means your VCR moves too quickly
from Record-Pause to Record mode.
•If the scene you tried to dub starts in progress, the
VCR is slow to start recording.
Random Assemble
Editing Menu
Program 1
Remote sensor
ADJUSTMENT OF VCR/CAMCORDER
TIMING
4 Point the remote control at the camcorder’s remote
sensor and press R.A.EDIT ON/OFF to make the
Random Assemble Editing menu disappear, then
press MENU. The Menu Screen appears.
5 Press + or – to select “ VIDEO” and press SET/
SELECT. The VIDEO Menu appears. Then, press + or
– to select “SYNCHRO” and press SET/SELECT. The
value for “SYNCHRO” is highlighted.
6 Based on the diagnostics performed, you can now
advance the VCR’s record timing by pressing +. You
can also delay the VCR’s record timing by pressing –.
The adjustment range is from –1.3 to +1.3 seconds,
in 0.1-second increments.
Press SET/SELECT to finish the setting.
7 Press + or – to select “ RETURN” and press SET/
SELECT twice.
Now perform Random Assemble Editing beginning
with step 4 on page 70.
NOTES:
● Before performing actual Random Assemble
Editing, do a few Random Assemble Editing
trial runs to check whether the value you
have input is appropriate or not, and make
adjustments accordingly.
● Depending on the recorder, there may be
situations where the timing difference
cannot be fully corrected.
VIDEO Menu
USING THE REMOTE CONTROL UNIT (cont.)