Technicolor - Thomson HP 270 - Manual (Page 37)

36
EN
D.S.C. PLAYBACK (cont.)
1 9 0 0
0 0
0 0
0 0
0 3
0 0
2 0 2 1
2 3 2 2
E X I T
100-DVC00021 VGA
2 4
D P O F
SE ECT L –
EXECUTE
CANCEL
DPOF
TO PRINT BY SELECTING STILL IMAGES
AND NO. OF PRINTS
1 Perform steps 1 through 4 on pg. 35.
2 Press + or – to select “SELECT” and press SET/
SELECT. Selection is complete. The DPOF Index
Screen appears.
3 Press + or – to move the green frame to the image
you wish to print and press SET/SELECT.
4 Select the number of prints by pressing + to increase
the number, or – to decrease the number and press
SET/SELECT.
Repeat steps 3 and 4 for the desired number of
prints.
•The number of prints can be set up to 15.
•To correct the number of prints, select the image
again and change the number.
5 Press + to select “EXIT” and press SET/SELECT.
Selection is complete. The Confirmation Screen
appears.
6 Press + or – to select “EXECUTE” and press SET/
SELECT. The normal playback screen appears.
•To cancel selection, press + or – to select “CAN-
CEL” and press SET/SELECT.
To Reset The No. Of Prints . . .
.... select “RESET” in step 5 on pg. 35. The number of
prints is reset to 0 for all still images.
DPOF Index
Screen
NOTES:
● If you load a memory card already set as shown above
in a printer compatible with DPOF, it will make prints
of the selected still images automatically.
● To print images recorded on a tape, first dub them to a
memory card (
੬ pg. 59).
CAUTION:
While performing the above, never disconnect power,
as this may cause the memory to be corrupted.
Display
Confirmation
Screen
Number of prints
Power Switch
MENU Button
Lock Button
VIDEO/MEMORY
Switch
SET/SELECT
Button
+, – Button