Tandberg Data N3 - Manual (Page 12)

TANDBERG Gatekeeper User Manual
6
xConfiguration Gatekeeper AutoDiscovery command in section 5.2
for more information.
12. Reboot the Gatekeeper by typing the command xCommand boot to make your new
settings take effect.
13. Disconnect the serial cable.
NOTE
To secure the Gatekeeper you should disable HTTP, HTTPS, SSH and Telnet, relying on the
serial interface for management. If you need IP connectivity, it is recommended that you use
SSH or HTTPS.
NOTE
If you do not have an IP gateway, configure it with an unused IP address that is valid in your
subnet as your IP gateway.