Tandberg Data N3 - Manual (Page 42)

TANDBERG Gatekeeper User Manual
36
Configuration commands Description
xConfiguration Gatekeeper AlternateGK
[1..5]: <IPAddr> List of Alternate Gatekeepers
’
IP addresses.
xConfiguration Gatekeeper
AutoDiscovery: <On/Off> Specifies if the Gatekeeper supports automatic registration of
endpoints.
The default is On.
xConfiguration Gatekeeper
CallsToUnknownIPAddresses:
<Off/Direct/Indirect> Specifies whether or not the Gatekeeper will attempt to call
systems which are not registered with any Gatekeeper. See
Calling for further detail.
The default is Indirect.
xConfiguration Gatekeeper
CallTimeToLive: <60..65534> Interval in seconds at which endpoints are polled to verify that
they are still in a call.
The default is 120 seconds.
xConfiguration Gatekeeper DNSResolution
Mode: <On/Off> Determines whether or not DNS lookup of H.323 URI
’
s is
enabled on this system.
xConfiguration Gatekeeper Downspeed
PerCall Mode: <On/Off> Determines whether or not the system will attempt to down-
speed a call if there is insufficient per-call bandwidth configured
to fulfill the request.
The default is On.
xConfiguration Gatekeeper Downspeed
Total Mode: <On/Off> Determines whether or not the system will attempt to down-
speed a call if there is insufficient total bandwidth available to
fulfill the request.
The default is On.
xConfiguration Gatekeeper
ForwardLocationRequests: <On/Off> Determines behavior on receipt of a location request from
another Gatekeeper. If set to
“
On
”
, if a location request cannot
be resolved locally, it will be forwarded to neighbor
Gatekeepers.
The default is On.
xConfiguration Gatekeeper LocalDomain
DomainName Domain that the Gatekeeper is responsible for. Used when
searching for matching endpoint registrations.
xConfiguration Gatekeeper LocalPrefix:
<prefix> Set the local zone prefix of the system.
xConfiguration Gatekeeper Policy Mode:
<On/Off> Determines whether or not the CPL policy engine is active.
The default is On.
xConfiguration Gatekeeper Registration
AllowList [1..1000] Pattern: <pattern> Specifies a pattern in the registration allowed list
xConfiguration Gatekeeper Registration
DenyList [1..1000] Pattern: <pattern> Specifies a pattern in the registration denied list
xConfiguration Gatekeeper Registration
RestrictionPolicy:
<None/AllowList/DenyList> Policy in use to determine who may register with the system.
The default is None.
xConfiguration Gatekeeper TimeToLive:
<60..65534> The interval at which the system polls the endpoint to make
sure it is still functioning. Specified in seconds.
The default is 1800 seconds.
xConfiguration HTTP Mode: <On/Off> Enables/disables HTTP support.
You must restart the system for changes to take effect.