Tandberg Data N3 User Manual
Page 38
TANDBERG Gatekeeper User Manual
32
NOTE
Make sure you transfer the release key file before transferring the software image. Also make
sure you name the files exactly as described below.
NOTE
The release key file should contain just the 16 character release key.
To upgrade using SCP, do the following:
1. Connect the supplied null-modem RS-232 cable from Data 1 to a PC running a
terminal program to monitor the transfer. You can also use SSH to monitor the
transfer.
2. Start the terminal program and configure it with baud rate 115200, 8 data bits, no
parity, 1 stop bit and no flow control.
3. Make sure the system is turned on and available on IP.
4. Upload the release key file using scp to the /tmp folder on the system e.g.
scp release-key roo[email protected]:/tmp/release-key
5. Enter password when prompted.
6. Copy the software image using SCP. The target name must be /tmp/tandberg-
image.tar.gz, e.g.
scp s42000n10.tar.gz [email protected]:/tmp/tandberg-
image.tar.gz
7. Enter password when prompted.
8. Wait until the software has installed completely. This should not take more than 2
minutes.
9. Reboot the system.
10. After about four minutes the system will be ready to use.