Tandberg Data N3 - Manual (Page 45)

39
Configuration commands Description
xConfiguration SubZones
TraversalSubZone Bandwidth Total Mode:
<None/Limited/Unlimited> Whether or not the traversal subzone is enforcing total
bandwidth restrictions. None corresponds to no bandwidth
available.
xConfiguration SubZones SubZone
[1..100] Bandwidth PerCall Limit:
<1..100000000> Per-call bandwidth available on the indexed subzone.
xConfiguration SubZones SubZone
[1..100] Bandwidth PerCall Mode:
<None/Limited/Unlimited> Whether or not the indexed subzone is enforcing per-call
bandwidth restrictions. None corresponds to no bandwidth
available.
xConfiguration SubZones SubZone
[1..100] Bandwidth Total Limit:
<1..100000000> Total bandwidth available on the indexed subzone.
xConfiguration SubZones SubZone
[1..100] Bandwidth Total Mode:
<None/Limited/Unlimited> Whether or not the indexed subzone is enforcing total
bandwidth restrictions. None corresponds to no bandwidth
available.
xConfiguration SubZones SubZone
[1..100] Name: <subzonename> Name of the indexed subzone.
xConfiguration SubZones SubZone
[1..100] Subnet IP Address: <IPAddr> IP to match an endpoint which belongs in this subzone.
xConfiguration SubZones SubZone
[1..100] Subnet IP Mask: <IPAddr> Subnet mask to match endpoints which belong in this subzone.
xConfiguration SystemUnit Name: <name> The name of the unit. Choose a name that uniquely identifies
the system.
xConfiguration SystemUnit Password:
<password> Specify the password of the unit. The password is used to login
with Telnet, HTTP(S), SSH, SCP, and on the serial port.
To set an empty password type
xConfiguration SystemUnit Password: ""
xConfiguration Telnet Mode: <On/Off> Enables/disables Telnet support.
You must restart the system for changes to take effect.
xConfiguration Traversal
AllowMediaDirect: <On/Off> Determines whether or not capable endpoints may send their
media directly to the Border Controller, bypassing the
Gatekeeper.
The defaults is Off.
xConfiguration Traversal Server
Address: <IPAddr> IP address of the Border Controller that this Gatekeeper should
connect to.
xConfiguration Traversal Registration
RetryInterval: <seconds> Frequency with which failed registrations with the Border
Controller should be repeated.
The default is 120 seconds.
xConfiguration Zones DefaultZone
Gatekeeper HopCount: <1..255> Maximum hop count to use when issuing LRQs to Gatekeepers
in this zone.
The default is 15 hops.
xConfiguration Zones TraversalZone
Gatekeeper HopCount: <1..255> Maximum hop count to use when issuing LRQs to Gatekeepers
in this zone.
The default is 15 hops.
xConfiguration Zones Zone [1..100]
Gatekeeper IP Address: <IPAddr> Specifes the IP address of neighbor gatekeeper.