Tandberg Data N3 - Manual (Page 9)

3
2 Installation
Precautions:

Never install communication equipment during a lightning storm.

Never install jacks for communication cables in wet locations unless the jack is
specifically designed for wet locations.

Never touch uninstalled communication wires or terminals unless the communication
line has been disconnected at the network interface.

Use caution when installing or modifying communication lines.

Avoid using communication equipment (other than a cordless type) during an
electrical storm.

There may be a remote risk of electrical shock from lightning.

Do not use communication equipment to report a gas leak in the vicinity of the leak.

The socket outlet shall be installed near to the equipment and shall be easily
accessible.

Never install cables without first switching the power OFF.

This product complies with directives: LVD 73/23/EC and EMC 89/366/EEC.

Power must be switched off before power supplies can be removed from- or installed
into the unit.
2.1 Unpacking
The TANDBERG Gatekeeper is delivered in a special shipping box which should contain the
following components:

Gatekeeper unit

Installation sheet

User manual and other documentation on CD

Rack-ears and screws

Kit with 4 rubber feet.

Cables:
o Power cables
o One Ethernet cable
o One null-modem RS-232 cable
Installation site preparations

Make sure that the Gatekeeper is accessible and that all cables can be easily connected.

For ventilation: Leave a space of at least 10cm (4 inches) behind the Gatekeeper
’
s rear
and 5cm (2 inches) on the sides.

The room in which you install the Gatekeeper should have an ambient temperature
between 0
o
C and 35
o
C (32
o
F and 95
o
F) and between 10% and 90% non-condensing
relative humidity.