Warming drawer operating instructions, Signal light, Thermostat dial / on knob – Thermador SEMW272 User Manual

Page 39: Suitable utensils, Moisture selector

Advertising
background image

SEM/SEMW Oven Care and Use Manual

37

Warming Drawer Operating Instructions

Open the drawer. The thermostat dial is on the right
side of the front frame.

Signal Light

The signal light is located below the thermostat dial
and turns on when the dial is set. It stays on until
the dial is turned back to the "OFF" position.

This light is visible through the light viewer in the
drawer front panel, when the drawer is closed. This
is a reminder that the heat is on.

The warming drawer will keep hot, cooked foods at
serving temperature. Always start with hot food.

DO NOT use to heat cold food other than proofing yeast
dough, crisping crackers, chips, and dry cereal, or
warming dishes or plates.

THERMOSTAT DIAL / ON KNOB

Dial

Indicator

Signal Light

Close-up of Dial

Drawer Interior: 22"W x 21"D x 7" H
Holds these utensils:

Two 9 x 13" Pyrex

®

, 3-quart dishes, side by

side

Two 9

1

/

2

x 15" Pyrex

®

, 4-quart dishes, side by

side

10

1

/

2

" plates, single or stacked

11" plates, single or stacked

Large 14" pizza, in box

Usable Space and Utensil Sizes

Suitable Utensils

Warming Drawer Details

Moisture Selector

At the top edge of the drawer trim are the words
“Moist” and “Dry.”

To keep foods moist, slide the knob inside the
drawer to the left (toward the word "moist"). This
closes the vents and seals the moisture inside the
drawer.

With the vent closed, the drawer is completely sealed
which keeps the hot food moist and soft. In this
setting condensation may occur around the inside
edge of the drawer.

To keep foods crisp, slide the knob to the right (to-
ward the word "dry"). This opens the vents and al-
lows the moisture to escape. With the vents open, it
is normal for moisture to collect on surfaces above
the warming drawer.

Advertising
This manual is related to the following products: