Tandberg Data VXA-320 (VXA-3) - Manual (Page 18)

4
P RODUCT M ANUAL 433689-01
C
HAPTER
1 F
EATURES
B
ACK
P
ANEL
C
OMPONENTS
– E
XTERNAL
T
APE
D
RIVE
Figure 1-5 shows the back-panel components of the external SCSI model of the
tape drive.
On/Off Switch Used to turn power on and off.
AC Power Connector Used to provide power through a grounded AC power
connector. A power cord is included with the tape drive.
Serial Connector Used to connect the tape drive to the serial port of a
computer for performing diagnostic operations with VXATool (see page 31 ).
SCSI Connectors (SCSI tape drive only) Used to connect the tape drive to the
SCSI bus with two SCSI cables or one SCSI cable and a terminator. These
connectors are 68-pin high-density LVD SCSI connectors.
SCSI ID Switch Used to set the SCSI ID.
Figure 1-5 External tape drive: back-panel components