Figure 2-5, Caution – Tandberg Data VXA-320 (VXA-3) User Manual
Page 27
O
CTOBER
2006
VXA-320 T
APE
D
RIVE
13
I
NSTALLING
THE
T
APE
D
RIVE
Using the screws provided with the tape drive, secure the tape drive in the
drive bay using one of the screw mounting combinations (see
).
3.
Power on the computer system or enclosure.
During the tape drive’s power-on self-test, the LEDs scroll sequentially
right to left, then left to right in amber and green. LED 4 illuminates in red
and green. When POST is complete, LED 4 illuminates in green. (See
Table 3-1, “LED states,” on page 20
for a description of the LED states.)
Caution
To avoid damaging the tape drive, follow these precautions:
Use only the M3
Ч
0.5
Ч
5 mm Phillips screws. Screw length must not exceed
5mm.
Ensure that the chassis is not distorted. (Alignment to the horizontal or vertical
plane should not exceed ±10°.)
Ensure that no objects (screw heads, cables, or adjacent devices) are pressing
against the frame.
Do not use a combination of the two sets of mounting holes.
Do not obstruct the ventilation fan on the back of the tape drive.
Figure 2-5 Screw mounting configurations (internal model)
3
3
Side mounting
Bottom mounting