At&t point-to-multipoint (custom) – Telos ZephyrExpress User Manual
Page 127
7-12 ISDN
ZEPHYREXPRESS SETTINGS (FOR YOU TO ENTER):
Set
Switch type
to:
PTP
SPIDs
: Not required
AT&T Point-to-Multipoint (Custom)
Available on AT&T 5ESS CO switches version 5E6 and above. This is becoming essentially
obsolete as NI-1 has the same capabilities.
It is not supported by ZephyrExpress.
Order AT&T Point-to-Point (Custom) or National ISDN-1 instead.
Northern Telecom DMS100 ‘Functional’ (Custom, PVC1)
(USA, Canada, some others)
Available on Northern Telecom DMS100 switches BCS 31 and above.
CO VALUES (TO TELL THE PHONE COMPANY)
Line Type: Basic Rate, Functional
EKTS: No
Call Appearance Handling: No
Non-Initializing Terminal: No
Circuit Switched Service: Yes
Packet Switched Service: No
TEI: Dynamic
1010XXX: Yes
Bearer Service: CSD and/or CSV as desired (see above)
Turn off features such as: packet mode data, multiline hunt, multiple call appearances, Elec-
tronic Key Telephone Sets (EKTS), shared directory numbers, accept special type of number,
intercom groups, network resource selector (modem pools), message waiting, hunting, in-
terLata competition, call waiting, etc.
Get: One or two SPID numbers, depending upon number of active B channels
ZEPHYR SETTINGS (FOR YOU TO ENTER)
Set
Switch type
to:
Natl I-1
SPIDs
: Enter one or two numbers, depending upon number of active B channels