Telos ZephyrExpress User Manual
Page 171
11-4 APPENDIX
CCS
CCS
CCS
CCS
CCS
— COMREX —
INTRAPLEX
CDQ2000 CDQ1000 CDQPrima Roadrunner Micro 56
DX200
DXP/DXR
4400
Micro 64
NEXUS
LAYER 3
N/S
N/S
YES
YES
N/S
N/S
N/S
N/S
LAYER 2
J-STEREO
YES
N/S
YES
N/S
N/S
YES
N/S
NO
DUAL
YES
N/S
YES
N/S
N/S
YES
N/S
N/S
MONO
YES
YES
YES
YES
N/S
YES
N/S
N/S
128 MONO
YES
N/S
YES
YES
N/S
YES
N/S
N/S
G.722
N/S
YES
YES
YES
YES
YES
YES
N/S
GENERAL NOTES:
•
YES = Compatible with ZephyrExpress.
•
N/S=Not supported by other codec.
•
ZephyrExpress supports ISO/MPEG Layer II at 48kHz sampling only.
•
ZephyrExpress supports “CCS CDQ protocol compatible” channel splitting for ISO/MPEG
Layer II stereo and mono 128 modes.
•
ZephyrExpress G/722 uses statistical sync. G.722 sample rate is fixed at 16 kHz regardless of
menu setting.
CCS NOTES:
•
CDQ 1000: Switch off H.221 (DIP switch 7 , on back, in down position; to “AUTO” mode) on
CDQ to transmit from CDQ to ZephyrExpress. Terminal adapter must have “BONDING”
turned off and be set to 64/56Kbps. Switch on ISO/MPEG bit stream (DIP switches 6 and 8 on
back, to up position).
•
CDQ 2000: Switch to “Decoder independent from encoder” (Decoder DIP switch #6 in up
position; “INDEPENDENT”). Terminal adapter must have “BONDING” turned off and be set
to 64/56Kbps.
•
Prima: must be set to front panel option “DECODER/GENERAL/INDEP=YES” OR Serial
port command “DIN YES”. To transmit G.722 sample rate must be set to 16 kHz. Only Primas
with serial numbers beginning with 2 support Layer 3.
COMREX NOTES:
•
DX200 must have ERROR PROTECTION set to “ON” and IMUX set to “TELOS/CCS” or
“CCS”. Terminal adapter must have “BONDING” turned off and be set to 64/56Kbps.
•
Nexus must have “H.221” off.