Telos ZephyrExpress - Manual (Page 23)

QUICK RESULTS 1-11
Set up an audio input and output
Plug the microphone into the MIC 1 INPUT jack on the back panel. Plug a stereo
headphone into the MON 2 OUT headphone jack on the front panel.
Monitor 2 Receive
routing switch
Monitor 2 Receive
volume
Monitor 2 Headphone Jack Monitor 2 Send volume
Mic 1 Volume
Mic 1 Routing Switch
Tap the MIC 1 routing switch until the letters AB above it light up green.
Talk into the mic, and raise its volume control until you see a good level on the top two
meters in the middle of the front panel. If you can’t adjust the mic for a good level, or the
letters
AB are turning red on peaks, you’ll have to change ZephyrExpress’ input
sensitivity 1 : see page 1-22.
Tap the MONITOR 2 RECEIVE routing switch until both letters A and B above it light up. You
shouldn’t hear anything in the headphones for now: if you do, make sure the MONITOR 2
SEND volume control is turned all the way down.
h
HOT TIP!
Some screens prompt you to Press jog to enter data or confirm a choice. It
means the same thing as tap the EDIT knob in toward the front panel ... but we
didn’t have enough room to say all that.
1 Or if you’re eager to place your first call, leave the sensitivity alone for now — our audio
circuits and codecs have a wide dynamic range — but be aware that any noise or
distortion you hear during this test is because of that mismatch.
Place the call to yourself
d
Verify that you can see the word Ready twice in the Status screen. If you can’t, check the
configuration steps on page 1-7.
Then press the DIAL button. A screen like this will appear:
If the word Manual... is not already highlighted, turn the EDIT knob to select it.