Component and assembly location, swo, A.8 appendix - replacing oven components, Removing the oven – TurboChef Technologies Residential Single and Double Wall Oven User Manual

Page 100

Advertising
background image

A.8

APPENDIX - REPLACING OVEN COMPONENTS

Component and Assembly Location, SWO

DANGER: Before removing or replacing any oven component, ensure the oven is removed from any
power source (i.e., the breaker is turned off ). Failure to do so can result in serious injury or death.

WARNING: Before removing or replacing any oven component, thoroughly read the safety instructions
found at the front of this manual and in Oven Systems (Section 5) and Troubleshooting (Section 6). Adhere to
all precautions and warnings outlined in these sections, as failure to do so could result in serious injury or death.

CAUTION: Before removing/installing any component, make sure it is disconnected from the wire
harness (where applicable).

Removing the Oven

In order to remove the oven from the wall, the two mounting screws (P/N: 104184), located on the inside of
the Speedcook oven’s outer trim, must be removed. Th

e oven may be safely pulled away from the wall

approximately 11” (280 mm) to remove the front top cover, lower EC access panel, and the door switch
covers. Any further removal requires the oven to be fully removed from the wall and placed upon a cart
capable of supporting approximately 230 lbs. (105 kg.).

Item Description

Item Part # Hardware Description

Hardware Part Number(s)

Air Switch

102009

Screw, 4-40 x 5/8, PPH, SS

101550 (x2)

Blower, Exhaust

104190

Screw, SH MTL, #8 x 1/2 Serrated PHTRH

101688 (x2)

Cover, Back, SWO

RWS-9018

Screw, SH MTL, #8 x 1/2 Serrated PHTRH

101688 (x11)

Door Skin, Replacement

RWD-3004-X

None

None

Door, Speedcook Oven

RWD-3019-X

Screw, SH MTL, #8 x 1/2 Serrated PHTRH
Cover, Hinge Pocket
Screw, #8-32 x 3/8, PPH, THD-Forming, PLT

101688 (x4)
RWD-9472 (x2)
104227 (x2)

Door, Speedcook Oven, Inner

RWD-3022

None

None

Electrical Compartment, SWO
(see pages A.16-A.17)

N/A

None

None

Front Trim, SWO
(see pages A.10-A.11)

N/A

Screw, #8 x 3/8 PH MOD TRUSS CRES
Screw, SH MTL, #8 x 1/2 Serrated PHTRH
Screw, #8 x 2.00 PH MOD TRUSS SS

101682 (x16)
101688 (x4)
104184 (x2)

Handle, Speedcook Oven

RWD-9011

Bolt, Handle, Speedcook Oven

RWD-9458 (x2)

Harness, Single

RWS-9002

None

None

Oven, Speedcook, SWO
(see pages -A.25)

N/A

None

None

Thermostat, 270F, Open on Rise

104228

Screw, #6 x 1/2, PPHD, DRL-PT, SS

101687 (x2)

Top Cover, Front

RWD-9356

Screw, SH MTL, #8 x 1/2 Serrated PHTRH

101688 (x7)

Top Cover, Rear

RWD-9355

Screw, SH MTL, #8 x 1/2 Serrated PHTRH

101688 (x11)

USB Port, Gen 2

103193

Screw, SH MTL, #8 x 1/2 Serrated PHTRH
Bracket, USB, Strap

101688 (x2)
RWS-9026

Advertising