TurboChef Technologies Residential Single and Double Wall Oven - Manual (Page 51)

OVEN
SY
STEMS
5.3
5. Follow the Removing/Reinstalling the Upper
Oven Door steps 9-16 (adjacent).
CAUTION: A microwave leakage test MUST
be performed! See page 5.4.
Left Lock Motor Assembly
Th e left lock motor assembly consists of a motor,
locking mechanism for the left side of the Speedcook
oven door, and three switches (primary, light, and
lock) that activate when a cam is turned while the
door closes.
Th e light switch controls the oven cavity light. Th e
light turns off when the door is closed, unless the
oven light switch (see page 2.1) is pressed.
Th e left lock switch closes to supply power to the
locking mechanism while the door is closed.
For Gen 1 ovens, the left (primary) interlock switch
(when closed in conjunction with the right interlock
switches) supplies power to the K3 and K4 relays,
which close and distribute power to the right and
left high-voltage transformers, allowing for micro-
wave operation.
For Gen 2 ovens, the door switch circuit starts and
returns on the control board (primary switch = J15-7
and J15-8). Control voltage leaves the control board
to the relay board for relay operation.
9. To install a new door, hold the door by the
sides and slide the door into the hinge pockets
in the same manner the door was removed.
10. Open the door completely.
11. Push both hinge locks back into their original
positions.
12. Close the door.
13. Reinstall the locking screws, insulation, and
insulation
covers.
14. Ensure the door opens and closes freely.
15. Push the oven back into its original position.
16. Perform a MW leakage test (see page 5.4).
Door Skin Replacement
If the oven door skin has sustained damage or if a
new color is wanted, the door skin can be replaced
without replacing the entire door. Follow the steps
below and refer to Figure 5.2.
1. Follow the Removing/Reinstalling the Upper
Oven Door steps 1-8 (see page 5.2).
2. Place the oven door on a fl at surface and ensure
that all surfaces are protected from damage.
3. Remove the four phillips screws (A) from the
bottom and the two door handle bolts (B).
Retain screws (A) and bolts (B) and handle (C)
for use on replacement door skin.
4. Install the new door skin using the hardware
from
step 3.
Figure 5.1: Hinge Pocket
1
3
2
A A
C
B
Figure 5.2: Speedcook Oven Door Detail