TurboChef Technologies Residential Single and Double Wall Oven - Manual (Page 105)

APPENDIX
-
REPLA
CING
OVEN
C
OMPONENT
S
A.13
Figure A.6: Control Housing Detail, DWO Gen 2 and SWO (diff erences)
Speaker
Upper Electrical Compartment, DWO Gen 1
DANGER: Before removing or replacing any oven component, ensure the oven is removed from any
power source (i.e., the breaker is turned off ). Failure to do so can result in serious injury or death.
WARNING: Before removing or replacing any oven component, thoroughly read the safety instructions
found at the front of this manual and in Oven Systems (Section 5) and Troubleshooting (Section 6). Adhere to
all precautions and warnings outlined in these sections, as failure to do so could result in serious injury or death.
CAUTION: Before removing/installing any component, make sure it is disconnected from the wire
harness (where applicable).
Diff erentiating Between DWO Gen 1 and DWO Gen 2
Use the serial number to tell if the oven being serviced is a DWO Gen 1 or DWO Gen 2 oven. To view the
serial number, open the Speedcook oven door and locate the serial plate (between the Speedcook oven door’s
hinges). If the serial number’s fi rst fi ve characters are “
TDO2D ” (or “TSO2D” for SWO models), the oven is a
Gen 2 oven. If the fi rst fi ve characters are NOT “ TDO2D ” (or “TSO2D”), the oven is a DWO Gen 1 oven.
If the oven being serviced is a DWO Gen 2 or SWO oven proceed to page A.16 for those model’s upper
electrical compartment illustrations.