TurboChef Technologies Residential Single and Double Wall Oven - Manual (Page 46)

4.4 INFO MODE
Oven Confi guration
From the Installer Setup screen, scroll down and
select “Oven Confi guration” to confi gure the oven
for double wall or single wall (Figure 4.16).
CAUTION: If the oven is not set to the proper
confi guration, it will not operate correctly.
NOTE: If the SD card is replaced, the oven must be
reconfi gured to the correct setting.
AC Voltage Confi guration
WARNING: DO NOT reconfi gure the
operating voltage of the oven to accommodate
existing voltage supply or the oven will not operate
correctly. Change this setting only if instructed by
TurboChef.
From the Installer Setup screen, scroll down and
select AC Voltage Confi guration to specify between
208 and 240 VAC (Figure 4.17).
Simulation/Demo State, and printf Mask
Simulation State, Demo State, and printf Mask are
confi gurations specifi c to manufacturer use. Do not
activate these confi gurations unless expressly
instructed by TurboChef.
Accessing the Version
Information
To access the software version number,
1. Ensure that the CookWheel is turned to off .
2. Press the info key
3. Scroll to and select Oven Setup.
4. Scroll to and select Version Information.
Installer Setup
Use the Installer Setup mode to test individual oven
components by turning them on or off and to set
diff erent confi guration settings for the oven. To
access Installer Setup:
1. From the Info Mode, select Oven Setup.
2. From Oven Setup, select Installer Setup.
3. Input the code 042259 (Figure 4.13).
Top (or Single Wall) Oven Component Tests
Select “Top Oven” to individually turn on and off
the following components (see Figure 4.14):
- Top and Bottom Blowers
- Top
Heaters
- Magnetrons
- Upper Door Lock
Bottom Oven Component Tests
NOTE: Not applicable for single wall ovens.
Select “Bottom Oven” to individually turn on and
off the following components (see Figure 4.15):
- Heaters
- Lower Door Lock
Info
Top Blower
Oven Setup Installer Setup Top Oven
Bottom Blower
Top Heaters
Mags
Info
Turn inner
knob to
change the
current
number. Push
inner knob to
select.
0 4 2 2 5 9
Oven Setup
Done
Info
To configure
for Single Wall
Oven, turn
knob, select
YES and press
START.
Double Wall Oven <---
... Single Wall Oven Configuration
Single Wall Oven
Info
Heaters
Oven Setup Installer Setup Bottom Oven
Lock/Unlock Door
Info
To configure
oven voltage,
turn knob to
select option
and press
START.
208 Volts AC
... AC Voltage Configuration
240 Volts AC <---
Figure 4.14: Top Oven Component Options
Figure 4.13: Input Password Figure 4.16: Oven Confi guration
Figure 4.15: Bottom Oven Component Options
Figure 4.17: AC Voltage Confi guration