TurboChef Technologies Residential Single and Double Wall Oven - Manual (Page 45)

INFO
MODE
4.3
NOTE: If the USB fl ash drive is not detected by the
oven, a message will appear (Figure 4.10). Ensure the
USB fl ash drive is correctly inserted and press Start
or the inner CookWheel knob to continue. Th
e oven
will continue to display this screen until the user
selects Cancel or a USB fl ash drive is detected.
CAUTION: DO NOT press any keys or
attempt to operate the oven until the software
update completes.
Backing Up/Restoring Favorites
If for some reason the SD card must be replaced,
you must back up Favorites to retain them.
To back up favorites before SD card replacement,
1. Ensure the oven is in Favorites.
2. Press the Info key.
3. Scroll to and select Oven Setup.
4. Select “Backup/Restore Customizations.”
5. Select “Backup to your USB Drive.”
6. Insert the USB fl ash drive into the USB port
located on top of the oven’s control panel
(Figure 4.8) and select “Begin.”
To restore favorites after SD card replacement,
1. Follow steps 1-4 above.
2. Select “Restore from your USB Device.”
3. Insert the USB fl ash drive into the USB port
located on top of the oven’s control panel
(Figure 4.8) and select “Begin.”
Updating the Oven Software
TurboChef
®
periodically releases software updates
(located at www.turbochef.com or call customer
service for assistance). Th
e oven can be updated via
USB fl ash drive (not included with the oven).
CAUTION: Software updates are generation
specifi c. Installing Gen 2 software on a Gen 1 oven
(and vice versa) will disable the oven. Replace the
SD Card to restore oven operation (see page A.18).
NOTE: When the oven’s software is upgraded, any
cook settings in View Last Cooked (10) in the Fa-
vorites mode will be lost. To permanently save these
settings prior to updating software, see page 2.9.
To update the oven’s software,
1. Ensure the oven is in Favorites.
2. Press the Info key.
3. Scroll to and select Oven Setup.
4. Scroll to and select Software Update.
5. Insert the USB fl ash drive into the USB port
located on top of the oven’s control panel
(Figure
4.8).
6. Press Start or the inner CookWheel knob
to select Update Software (Figure 4.9).
NOTE: A USB extension cable (P/N: 103194) is
available for easy access to the port. Contact Turbo-
Chef customer service for more information.
Info
Oven Setup Software Update
Software update can take up to
10 minutes. Please do not disturb the
oven until the update is complete.
Begin Update
Info
Oven Setup Software Update
Insert USB flash drive into the
USB port located on top of the oven
control panel.
Update Software
Info
Oven Setup Software Update
USB flash drive can not be found.
Please ensure the USB flash drive is
properly connected to the USB port.
Try Again
Figure 4.11: Begin Update Screen
Figure 4.10: USB Flash Drive Can Not be Found Screen
Figure 4.9: Insert USB Flash Drive Screen
Figure 4.8: Inserting USB Flash Drive
Figure 4.12: Logo Screen