TechniSat TechniBox VIACAM - Manual (Page 16)

> Now use the up/down arrow keys to select the entry LNB Settings
> Confirm by pressing the OK key.
The menu
LNB Settings
will be displayed.
The following selections can be made in this sub-menu:
5.4.1 Switching DiSEqC on or off
DiSEqC (
D
igital Satellite
Eq
uipment
C
ontrol) is a digital signal that can control the functions
of DiSEqC-compatible components via the antenna connection.
If your external installation features DiSEqC components, you should enable the DiSEqC
control function:
>
When this entry is highlighted, use the OK key to switch the DiSEqC function on or
off .
5.4.2 Adjusting the Switching Matrix and LNB Properties
The menu reflects the four switching criteria of the DiSEqC control.
Your receiver is pre-programmed to receive ASTRA broadcasts on switch setting A/A, and
EUTELSAT signals on setting B/A of a Multiswitch. Should the switching matrix of your exter-
nal receiving unit be set up differently, or should you wish to receive satellite signals other
than those mentioned, you can adjust the receiver settings as follows:
>
Use the up/down arrow keys to select the DiSEqC switch position (1-4) that you
wish to use for allocation to a satellite (e.g. A/B 3 No Satellite ), and highlight the
appropriate entry.
> Press the OK key to confirm.
A list of several satellites will be displayed, from which you can make your selection.
> Use the up/down arrow keys to select the appropriate satellite.
Pressing the up/down arrow keys will move the marker by one line at a time, up or
down, while the left/right arrow keys will take you to the previous or following pages
respectively.
Should the satellite you are looking for not be included in the list, please select one of
the spare settings, which are marked User 1 to User 15.
16
bed_anl_ViaCam_engl_2.qxd 30.03.01 14:21 Seite 16