TechniSat TechniBox VIACAM - Manual (Page 25)

6.13.7.2 Preselect Programme
> Mark the desired programme by using the
arrow
keys.
> Pressing the OK key will automatically preselect the programme, and it can be
viewed as soon as the programme begins broadcasting.
> Press the
Back
key to return to the previous table.
6.13.7.3 Activate VCR (Timer mode)
The
Activate VCR
function allows you to switch your receiver on or off for a selected pro-
gramme, e.g. in order to record this in your absence. Please note that you must also pro-
gramme your VCR in order to record the programme.
>
Use the
arrow
keys to mark the selected programme.
> Press the red function key.
The selected entry will now be displayed in red.
Your receiver will be switched on at the time when the selected programme is due to
begin.
If the receiver is switched on by the timer, the letter "t" will be shown on the display,
together with the channel number. In this mode, most of the functions of the remote
control are disabled in order to prevent an accidental premature interruption of the
recording.
Please note that this function can only be executed if your receiver is switched
on, either fully or in standby mode.
If the receiver is in standby mode, the activated timer will be indicated by blinking of
the two dots (colon) in the time display.
> Press the
Back
key to return to the previous display.
Disabling the timer function
If you want to cancel a timer command entered via the EPG, repeat the above steps, then
cancel the timer setting by pressing the
red function key.
In order to interrupt/disable while the timer is actively in operation, switch off the receiver by
means of the
on/standby key. When you press this key again, the receiver will be switched
on, and you can continue with normal operation.
6.13.7.4 EPG Summary
You can use the EPG Summary in order to display the current day's programme of a single
channel. This can be done as follows:
>
Press the
EPG
key
The EPG table " Now/Current " will be displayed
> Press the green function key.
The EPG Summary will be displayed.
25
bed_anl_ViaCam_engl_2.qxd 30.03.01 14:21 Seite 25