TechniSat TechniBox VIACAM - Manual (Page 21)

grammes, the language and other sound settings revert to the default settings, resp.
your pre-selected settings. If you wish to continue receiving sound in AC3 format, you
will have to repeat the selection procedure as described above.
6.6 TV/Radio selection
Your receiver has been pre-programmed with a selection of radio as well as TV programmes.
When selecting a radio programme, the TV image is switched off, and only the radio pro-
gramme name is displayed.
>
Use the TV/Radio key to select radio mode.
The receiver will automatically go to the last radio programme selected.
> Press the
TV/Radio
key again, and the last TV programme selected will be display-
ed again.
6.7 Return to previous programme selected
> Press the Back key on the remote control to view the last programme previously sel-
ected.
> Press the same key again to return to the programme viewed before the change.
6.8 Displaying Time and Programme Information
This function allows you to view information about the programme currently selected.
>
Press the
blue
key in order to display information on the current programme.
The bottom of the screen will now display the current time, the current channel as well as the
name of the current programme, including the starting and end times of the programme, if
these details are broadcast by the channel concerned.
6.9 Additional Programme Information
In as far as such information is provided by the broadcasters, you can obtain additional pro-
gramme information by pressing the Programme Info key.
>
Pressing the yellow key will open a further viewing window on your screen.
Information relating to the current programme will be displayed.
> Now press the
OK
key to obtain information about the following programme.
> Pressing the yellow key again will cause the on-screen information to disappear.
6.10 Transponder Information
> Press the
green
key (Transponder Info) to display data relative to the transponder
selected.
> Press the same key again to return to the normal video display.
6.11 Video text
Where broadcast, video text will be sent through to your TV set. Use the remote control of
your TV set to utilise the video text function. Should your TV set experience problems, e.g.
video content and text are superimposed, you should set your receiver to
FBAS mode
(Point 5.3)
21
bed_anl_ViaCam_engl_2.qxd 30.03.01 14:21 Seite 21