TechniSat TechniBox VIACAM - Manual (Page 37)

Satellite
In this line you must select the satellite corresponding to the selected transponder.
>
Use the up/down arrow keys to select the Satellite option .
> Press
OK
to display a table listing four satellites.
> Use the up/down arrow keys to mark the selected satellite.
> Confirm with the OK key.
The selected satellite has now been acquired by the menu.
Transponder frequency
>
Use the
up/down arrow
keys to mark the entry
Transponder frequency
.
> Use the numeric key pad to enter the correct frequency in this line.
Polarisation
>
Use the up/down arrow keys to mark the entry Polarisation.
> Use the
OK
key to enter the polarisation plane (
h
orizontal or
v
ertical) on which the
desired programme is broadcast.
Symbol rate
The symbol rate indicates the volume of data transmitted per second. An example might be
27500, indicating transmission of 27500 symbols per second.
>
Use the up/down arrow keys to mark the entry Symbol rate .
> Use the numeric key pad to enter the correct symbol rate.
> Once you have entered all the information, start the search by using the
up/down
arrow keys to mark the entry Start search .
> Confirm with the OK key.
Please note any notes and information displayed on the screen.
7.7.4 Channel/Programme
If a channel cannot be found by means of any of the first three search modes, it may be
necessary to enter a programme-specific Service-ID-Number. This number will be obtainable
directly from the service provider/broadcaster, or from the Internet.
Select the menu
>Search>Programme
.
> Use the up/down arrow keys to mark the entry Programme.
> Confirm with the OK key.
The menu
>Search>Programme
will be displayed
37
bed_anl_ViaCam_engl_2.qxd 30.03.01 14:21 Seite 37