Texas Instruments 5000 - Manual (Page 106)

4.2.5.3 Running PC-Doctor
PC-Doctor is a DOS-resident program that can be run from either hard disk
or from the bootable diskette you previously created.
1. From the C:\ prompt, type:
PCDR
and press Enter
2. The Diagnostics Program loads into system memory, and the LCD
displays the diagnostics Header.
n
Note: There are a number of command-line switches that can be entered
when starting up PC-Doctor to enable loopback testing of serial/parallel
ports, work from the remote menu if performing remote operations, etc. To
get a listing of the available command-line switches, startup PC-Doctor with
the following command:
PCDR /?
and press Enter.
4.2.5.4 Quitting PC-Doctor
To exit PC-Doctor, Select the Quit pull down menu and then select the Quit
to DOS option.
n
Note: For additional information, press F1 twice to access the online Refer-
ence manual for PC-Doctor.
4-14 Troubleshooting Procedures