Texas Instruments 5000 - Manual (Page 126)

5.5.11 Removing/Replacing the Sleep
Switch Board
To remove and replace the Sleep Switch Board Assembly, reference Figure
5-14 and perform the following procedure:
1. Open up the base assembly as described in the previous paragraph
(Paragraph 5.5.6).
2. Unplug the cable connector from J11 on the Sound/PCMCIA Board.
3. Remove the screw securing the LED Board to the metal bracket above
the Expansion Bus Connector. Remove the LED Board assembly.
4. Replacement is essentially the reverse of Steps 1 through 4 above.
To Connector J12
on Main Board
Sleep Switch Board Assembly
Figure 5-14 Sleep Board Assembly, Removal/Replacement
5-20 Field Service