Texas Instruments 5000 - Manual (Page 133)

5. Install the replacement LCD Cover Assembly onto the base of the
notebook and secure using the hinge screws. Reconnect the two video
cables under the DAB Board and secure the DAB insulator to the top
of the board.
6. Install the original LCD bezel .When replacing the bezel, ensure that
the microphone is correctly positioned between the plastic tabs to
prevent binding when snapping the bezel in place. Also ensure that
the two locking pawls come throught the slits in the bezel (near the
top of the bezel). Replace the bezel screws and bezel screw rubber
inserts. Also replace the hinge covers. Test unit by carefully opening
and closing the notebook and looking for and correcting any signs of
binding.
Microphone Assembly
Right side Hinge Screws
Left Side Hinge Screws
Removing the Hinge Screws
Removing the Bezel
Step 1: Remove two
Snap On Plastic Hinge
Covers
Step 2: Remove two plugs and remove recessed screws..
Step 3: Gently pry off the
Display Bezel (held by clips)
Figure 5-19 LCD Cover Assembly, Removal/Replacement
Field Service 5-27