Texas Instruments 5000 - Manual (Page 127)

5.5.12 Removing/Replacing the
Sound/PCMCIA Board
To remove and replace the Sound/PCMCIA Board, reference Figure 5-15
and perform the following procedure:
1. Open up the base assembly as described in the previous paragraph
(Paragraph 5.5.6). Remove any installed PCMCIA options (Paragraph
5.5.2).
2. Unplug the cable connectors from J5, J10, J11, J12, on the
Sound/PCMCIA Board.
3. Gently rock and lift the board to dislodge from the bottom connector
holding it to the Main Board. Remove the Sound/PCMCIA Board
assembly.
4. Replacement is essentially the reverse of Steps 1 through 3 above.
Figure 5-15 Sound/PCMCIA Board, Removal/Replacement
Field Service 5-21