Texas Instruments 5000 - Manual (Page 130)

5.5.14 Removing/Replacing the Display
Bezel
To remove the Display Bezel (to gain access to Cover-Display FRU’s), refer to
Figure 5-17 and perform the following procedure:
1. Turn off the computer and disconnect the ac power adapter (if it is
attached).
2. Disconnect any peripheral device interface cables from the external
interface connectors.
3. With the notebook open, remove the two hinge covers by squeezing
them and gently prying upwards with a small flat-blade screwdriver.
4. Using a small flat-blade screwdriver, gently remove the two screw
covers near the base of the LCD/Cover Assembly. Remove the two
screws located behind the screw covers.
c Caution: If the notebook is powered up with the LCD bezel removed,
you can be exposed to high voltages which could result in shock and
equipment damage. Ensure that the batteries and AC adapter are re-
moved from the notebook when working on the LCD/Display assembly.
5. The display bezel is held in place with clips and can be removed by
gently prying each snap loose.
6. To reinstall the Display Bezel, reverse the removal procedure described
in Steps 1 through 5 above. Carefully reposition the microphone unit
at the top of the display and ensure all cables are tucked in before
closing up the Cover-Display Assembly.
Step 1: Remove two
Snap On Plastic Hinge
Covers
Step 2: Remove two plugs and remove recessed screws..
Step 3: Gently pry off the
Display Bezel (held by clips)
Figure 5-17 Display Bezel, Removal/Replacement
5-24 Field Service