Texas Instruments 5000 - Manual (Page 79)

2.7 Installing the AC Power Adapter
Use the following procedures to connect the AC Adapter to the system:
c
Caution: Use only the AC Adapter supplied with the computer; other
adapters can damage the unit.
1. Remove the AC adapter from the packaging. Connect the round coaxial
connector supplied with the notebook to the DC IN power receptacle
on the left rear of the notebook as shown in Figure 2-17.
2. Connect the female side of the AC Power cord to the AC Adapter and
connect the male end to a grounded AC outlet.
Notebook without Port Replicator
Attaching AC Adapter to Docked Notebook
Figure 2-17 Installing the AC Adapter
Installation 2-19