Transition Networks CPSMC0800-100 - Manual (Page 12)

12
CPSMC0800-100 PointSystem ™ Chassis
po
wer supply
3 Powering the CPSMC0800-100
The CPSMC0800-100 chassis can be powered through an AC or DC Power Supply.
An optional auxilliary power supply, with Instant Fail Over protections, is also avail-
able.
NOTE: The CPSMC0800-100 8-Slot chassis does not have an ON/OFF switch.
• Power up the chassis by connecting the power supply.
• Power-down the chassis by disconnecting power supply.
WARNING: THE AC AND DC POWER SUPPLIES CONTAIN NO USER-SERVICA-
BLE PARTS. DO NOT ATTEMPT TO SERVICE EITHER POWER SUPPLY. FAILURE
TO OBSERVE THIS CAUTION COULD RESULT IN EQUIPMENT DAMAGE
AND/OR PERSONAL INJURY OR DEATH.
NOTE: Contact Technical Support for any questions concerning power supply.
3.1 Primary Power Supply
The CPSMC0800-100 includes an internal power supply, which is accessed through
a power inlet on the front panel. The power cord is included.
To power the CPSMM0800-100 8-Slot chassis through the Primary Power Supply:
1. Connect the female end of the power cord to the Power Inlet on the front panel
of the chassis.
2. Plug the male end of the power cord into the correct voltage rack or wall sock-
et.
3. Verify that the 8-Slot chassis is powered by observing the illuminated Power
LEDs on the Slide-in-Modules and by the fan operation.
Tech Support: 7am-6pm CST (GMT -6:00) 1-800-260-1312 International: 00-1-952-941-7600
10BASE-T INPORT
MCCM10
MGMT
MASTER
OUTPORT
12C 12C-1 TERM INIT
RX TX
LNK PWR RESET
DB-9
CFETF1
10
SPD
PWR
FRX CRX
FLNK CLNK
10/100TX RX TX 10/100SX LKS
PWR
LKM Multimode Singlemode TX RX TX RX
CFETF1
10
SPD
PWR
FRX CRX
FLNK CLNK
10/100TX RX TX 10/100SX LKS
PWR
LKM Multimode Singlemode TX RX TX RX CPSMC-0800
8-Slot Chassis
Mpls, MN 55344 Mpls, MN 55344
Input Power: Input Power:
110-240 VAC 110-240 VAC
1.6A max. (60W max) 1.6A max. (60W max)
50/60 Hz 50/60 Hz
Power Inlet
Power Cord