Transition Networks CPSMC0800-100 - Manual (Page 8)

8
CPSMC0800-100 PointSystem ™ Chassis
slide-in-modules
Tech Support: 7am-6pm CST (GMT -6:00) 1-800-260-1312 International: 00-1-952-941-7600
2.2.3 Replacing the Media Converter Slide-in-Modules
CAUTION: Wear a grounding device and observe electrostatic discharge precau-
tions when replacing Media Converter Slide-in-Module(s). Failure to observe this
caution could result in damage to, and subsequent failure of, the Media Converter
Slide-in-Module(s).
NOTE: The Media Converter Slide-in-Modules are hot-swappable.
To replace a Media Converter Slide-in-Module:
1. Remove the Media Converter Slide-in-Module to be replaced by loosening the
one (1) screw that secures the Slide-in-Module to the CPSMC0800-100 chassis
front. Slide the Media Converter Slide-In-Module from the CPSMC0800-100
chassis.
2. Align the replacement Media Converter Slide-in-Module with the chassis instal-
lation slot so that the panel fastener screw is to the left.
3. Carefully slide the replacement Media Converter Slide-in-Module into the
installation slot.
NOTE: Ensure that the Media Converter Slide-in-Module is firmly seated against
the back of the chassis.
4. Install the replacement Media Converter Slide-in-Module by carefully rotating
the attached panel fastener screw clockwise to secure the Media Converter
Slide-in-Module to the chassis.
10BASE-T INPORT
MCCM10
MGMT
MASTER
OUTPORT
12C 12C-1 TERM INIT
RX TX
LNK PWR RESET
DB-9
CFETF1
10
SPD
PWR
FRX CRX
FLNK CLNK
10/100TX RX TX 10/100SX LKS
PWR
LKM Multimode Singlemode TX RX TX RX
CFETF1
10
SPD
PWR
FRX CRX
FLNK CLNK
10/100TX RX TX 10/100SX CPSMC-0800
8-Slot Chassis
Mpls, MN 55344 Mpls, MN 55344
Input Power: Input Power:
110-240 VAC 110-240 VAC
1.6A max. (60W max) 1.6A max. (60W max)
50/60 Hz 50/60 Hz
LKS
PWR
LKM Multimode Singlemode TX RX TX RX
Panel Fastener Screw