Transition Networks CPSMC0800-100 - Manual (Page 17)

17
CPSMC0800-100 PointSystem ™ Chassis
chassis
To cascade two or more CPSMC0800-100 8-Slot chassis:
1. Locate one (1) Transition Networks CPSMC0800-100 Management Module cas-
cade cable (with RJ-45 connectors installed at both ends) for each set of two (2)
chassis to be cascaded.
NOTE: Transition Networks Management Module cascade cables are one (1)
meter long. Ensure that the chassis are installed within one (1) meter of each
other.
2. At the first chassis in the series: Plug the RJ-45 connector at one end of the cas-
cade cable into the Management Module’s RJ-45 port labeled “OUTPUT”.
3. At the next chassis in the series: Plug the RJ-45 connector at the other end of
the cascade cable into the Management Module’s RJ-45 port labeled “INPUT”.
4. At the same chassis as in step 3: Plug the RJ-45 connector at one end of the
cascade cable into the Management Module’s RJ-45 port labeled “OUTPUT”.
5. At the next chassis in the series: Plug the RJ-45 connector at the other end of
the cascade cable into the Management Module’s RJ-45 port labeled “INPUT”.
6. Repeat steps 4 and 5 until all chassis have been connected.
4.3 Connecting the Slide-in-Modules to the Network
Once the CPSMC0800-100 chassis has been installed, the Media Converter Slide-
in-Modules may be connected to the network.
CAUTION: Connect input/output network cables ONLY to Media Converter Slide-
In-Module connectors within the same network protocol (such as Ethernet-to-
Ethernet, Fast Ethernet-to-Fast Ethernet, ATM-to-ATM). Failure to observe this cau-
tion will cause data transfer to fail.
Refer to User’s Guides included with the Media Converter Slide-In-Modules for
cabling specifications and instructions.
Tech Support: 7am-6pm CST (GMT -6:00) 1-800-260-1312 International: 00-1-952-941-7600
10BASE-T INPORT
MCCM10
MGMT
MASTER
OUTPORT
12C 12C-1 TERM INIT
RX TX
LNK PWR RESET
DB-9
CFETF1
10
SPD
PWR
FRX CRX
FLNK CLNK
10/100TX RX TX 10/100SX LKS
PWR
LKM Multimode Singlemode TX RX TX RX
CFETF1
10
SPD
PWR
FRX CRX
FLNK CLNK
10/100TX RX TX 10/100SX LKS
PWR
LKM Multimode Singlemode TX RX TX RX CPSMC-0800
8-Slot Chassis
Mpls, MN 55344 Mpls, MN 55344
Input Power: Input Power:
110-240 VAC 110-240 VAC
1.6A max. (60W max) 1.6A max. (60W max)
50/60 Hz 50/60 Hz
Check the individual User's Guides for specific information on
how to connect each Slide-in-Module to the network.