Tally Genicom 5040 User Manual
Page 15
User guide
Installation
7
When selecting the printer location, observe the following additional
instructions:
Never place the printer in the vicinity of inflammable gas or
explosive substances.
`
Protect the printer from shock, impact and vibration.
`
Be sure to connect the printer to a socket with the correct mains
voltage.
`
Do not expose the printer to direct sunlight. If you cannot avoid
placing the printer near a window, protect it from the sunlight with
a curtain.
`
When connecting the computer with the printer, make sure not to
exceed the permitted cable length (see
`
Ensure sufficient distance between the printer and any heating radi-
ators.
`
Avoid exposing the printer to extreme temperature or air humidity
fluctuations. Above all take care to avoid the influence of dust.
`
Always disconnect the system from the mains before opening the
device to perform maintenance work or remedy errors.
`
It is recommended to install the printer in a place which is acousti-
cally isolated from the workplace because of the noise it may pro-
duce.
STOP