Temco Tool 36RDVN - Manual (Page 25)

25
RDVN Series Direct Vent Gas Fireplace
20007628
For units equipped with ‘HI/LO’ valves the flame
adjustment is accomplished by rotating the ‘HI/LO’
adjustments knob located near the center of the gas
control valve. (Fig. 46)
It is important to periodically perform a visual check of
the pilot and burner flames. Compare them to Figure
47.
If the flame patterns appear abnormal contact a
qualified service provider for service and adjustment.
Flame Characteristics
Flame & Temperature Adjustment
LO
HI
FP390
FLAME ADJUSTMENT KNOB
11/21/96
Turn
counterclockwise
to increase
flame height
Turn clockwise
to decrease
flame height
Fig. 46 Flame adjustment knob for SIT valve.
FP1229
Pilot flames
11/02
FP1229
Fig. 47 Correct pilot flame appearance.
TL121
DV1000/DV1200
final position logs
12/11/03 djt
TL121
Fig. 44 Logs in final position (36RDV shown).
7. Ember tray ends beyond burner port area and area
in front of grate may be covered with lava rock to
suit individual appearance preferences.
8. Purge lines and test pilot operation.
9. Replace glass door. The door must be installed
before operating the fireplace.
10. Flame should not impinge (touch) on logs.
WARNING: Do not place lava rock or any other materi-
als on the burner. Use only certified material supplied
with this fireplace. Using uncertified materials will void
the warranty.
TL122
Dv logs
side view
12/11/03 djt
Back Log
Slot
Bracket
Bracket
Twig
Front Log
TL122
Fig. 45 Side view of logset.
33RDV
36/39RDV
Twig
Back Log
Bracket
Bracket
Front Log