Toshiba E-STUDIO 850 - Manual (Page 150)

148
5.USING THE EDITING FUNCTIONS
13.JOB BUILD (Cont.)
5
4 After “Press START button to copy after changing settings.” appears,
perform the settings for the 1st job and the common settings for all
jobs.
• Press the [SETTINGS] button to confirm the settings.
• To change the settings, press the [FUNCTION CLEAR] button, and then start the procedure again from step 1.
5 Press the [START] button.
• The scanning of the originals for the 1st job starts.
6 After “Press START button to copy after changing settings.” appears,
place the originals of the 2nd job. Perform the settings for the 2nd job.
• Note that copying will be performed in the same modes as those of the 1st job if the settings are not changed.
• Press the [SETTINGS] button to confirm the settings.
7 Press the [START] button.
• The scanning of the originals for the 2nd job starts.
• Repeat steps 6 to 7 until all the originals have finished being scanned.
8 After all the originals have finished being scanned, confirm the num-
ber of copies on the menu and change if needed.