TC electronic SDN BHD 48 - Manual (Page 16)

CONTROL PANEL - MIXER PAGE
14
19 AUX Channels
This is the Fabrik R return level.
Press “M” to mute the Fabrik R return.
Even on the AUX channels you are allowed
to insert one of the Fabrik C Studio
compressors.
Assuming you use the AUX channels to set
up one or two mixes for the headphone sets
used by the recording artists, you may want
to hear what you are currently sending to the
AUX channels in the control room main
monitors. Press “TO MAIN” to send to the
AUX send to the main mix.
Let us take a closer look at the Talkback mixer-channel
Channel naming and channel input metering
is described previously.
Fabrik C studio - even on talkback
Even on the talkback channel you can insert
one of the Fabrik C compressors if you like.
Dim level
When activating the talkback function you
most likely want to attenuate the mix level
in the performer’s headphones. The Dim
Level knob sets this level. The dim level can
never be set higher than the normal level.*
Talkback routing
The AUX sends are typically used for setting
individual mix levels on the two headphone
outputs. The AUX 1, AUX 2 and MAIN
buttons determine to which outputs the
talkback signal should be sent.
Talk button
Press the TALK button on the Studio Kontrol
Remote or on the mixer.
* Listen-back function
Per default all output channels are muted when talkback
is activated. It is, however, possible to keep feeding
selected channels to the outputs, even when the talkback
is invoked.
For this we use the “Listen-back” function. Press TALK
and you will see an “L” button appearing just below the
MUTE “M” and SOLO “S” buttons on each channel.
Click the “L” on the channels you want to feed to the
outputs when talkback is active.
Notice that the listen-back function overrides the dim
function in order to be able to communicate with the
recording musicians.