TC electronic SDN BHD 48 - Manual (Page 19)

Input section
Overview of the input channels. Idle inputs are grayed
out. If a device is connected to an input the icon will
display this.
Example:
Nothing connected XLR device connected
1 Mic Ch1-4
Channels 1-4 connections on the front panel are auto-
sensing. They automatically detect whether you have
connected an XLR (microphone) or 1/4” jack
(instrument), and display this graphically.
These are the options
Nothing connected Mic/XLR Inst./jack
Optical Format
2 Optical Input Format
Select between ADAT or TOS.
Stand-Alone Clock Settings
To apply the "stand-alone clock settings":
- power off the unit
- disconnect firewire cable form unit
- switch on the unit again
SETUP PAGE
17
3 Sync Source
See the options in the illustration above.
Studio Konnekt 48 will attempt to lock to the selected
sync source. A steady orange LED above the meter for the
relevant format indicates “lock”. A flashing LED indicates
“no lock”.
4 Nominal Sample Rate
Depending on the selected sample rate there are few
restrictions with regards to the plug-ins.
Options are:
44.1 kHz
Both Fabrik R Studio and two Fabrik C
& 48 kHz Studio are available
88.2 kHz Fabrik R Studio and Fabrik C Studio
& 96 kHz are available
176,4 kHz Fabrik R Studio and Fabrik C Studio
& 192 kHz are not available
5 File
The output section offers numerous choices of
configuration and this section therefore has its own
preset menu. Presets contain all the parameters in the
output section. Load and Save files via this menu.