TC electronic SDN BHD 48 - Manual (Page 51)

FABRIK C STUDIO
49
• Grab the “C”, “L” or “G” handle using the left mouse button.
• Press and hold the Alt key (Mac: Command key), while moving the mouse in a circle. The “compass” function
is now active and you can select one of 2 to 6 directions.
• Release the Alt key (Mac: Command key)and move the mouse still holding the left mouse button pressed to
select desired values.
• Release mouse button to release the grid.
Adjusting Parameters - Compressor section
As described in the previous section the parameters on the 4 Compression pages are adjusted simply by grabbing and
moving the “S”, “G”, “C” and “L” handles - however, a few extra cool features are available.
Grid
On the Source pages the “S” handle moves in vertical and horizontal directions only, but on the Compression Control, Level
and Gain pages the “C”, “L” and “G” handles move freely in all directions. You may, however, see the advantage of moving
the handle in one direction only. Therefore it is possible to lock a direction in a “grid”.
Compression
- Full-band mode
The Compressor is in Full-band mode when “3-band” is
not marked.
In 3-band mode the Compression Control COMP and the
Level Control LEVEL handle the distribution of
compression and level between the 3 bands. In Full-band
mode these controls are redundant and not available.
In Full-band mode only Source and GAIN apply.