TC electronic SDN BHD 48 - Manual (Page 20)

Routing Channels to Outputs
Introduction - basics
The main purpose of the output section is routing of the
physical, DAW and FireWire input channels to the
physical outputs. Starting from left going to right we have
the:
- the Source select that allows you to select the input
you intend to route
- the option of routing source signal to any of the three
speaker sets A, B, C and furthermore setting individual
trim and delay for each source
- giving the outputs personal labels
.....let us take a look at each element of the Output
section in detail.
6 Link button
This button allows you to link/unlink channel pairs.
Example: Typically, you would prefer having main outputs
linked, but you may unlink main L and main R if
individual delay or trim is needed.
Linked
Unlinked
7 Source select
Via the source select drop down menu you select the
signal you are about to route. The options are:
Physical:
These are the physical inputs on Studio Konnekt 48.
18
SETUP PAGE