TC electronic SDN BHD 48 - Manual (Page 50)

FABRIK C STUDIO
48
Compressor control
The Low, Mid and High parameters indicate the set
compression amount for the three bands.
• Grab COMP and position this icon freely within the
triangle to distribute the amount of compression on the
three bands.
If the compression should primarily be on the low end
frequencies move COMP in that direction. Likewise with
the Mid and High areas.
Where the Gain parameter is used to gain the input of the
Compressor and also set the Make-up gain on the output,
the Compression Control adjusts the individual
compression amount on the three bands.
Compression
3-band mode only
Compressor Control page
Level Control
Depending on the amount of applied compression you
may need to level compensate the three individual bands.
• Grab the LEVEL and position this handle freely within
the entire triangle.
Whereas the Make-up Gain function on the Gain page is
used as a general level compensation on the entire signal,
the Level control can be used to set the level of the three
bands individually.
Compression
3-band mode only
Level page