TC electronic SDN BHD 48 - Manual (Page 58)

56
FABRIK R STUDIO
The Color parameter controls are advanced controls
handling the sonic spectrum of the Reverb diffuse field.
Try adding a bit of HiColor if you feel the level of reverb is
correct, but still doesn’t stand out as intended.
LoColor
Low Color adjustment of the Decay.
HiFactor
The HiFactor parameter is used to enhance or attenuate
the frequency area set by the HiColor parameter.
HiColor
HiColor adjustment of the Decay. This parameter selects
frequency area in focus.
Color page Level page
The relation between Dry, Early and Reverb levels defines
the perceived distance of a source. The less dry the signal
compared to Early and Reverb levels, the greater the
perceived distance. Early and Reverb levels set the
relation between the amount of room definition compared
to the reverb diffuse field.
If the Kill Dry button is pushed, Dry Level is fixed at off.
If the Kill Wet button is pushed, Early and Reverb Levels
are fixed at off.
Dry
Range: Off, -24 dB to 0 dB
Sets the amount of dry level passing through the algorithm.
Early
Range: Off, -24 dB to 0 dB
The Early Reflections are the defining basis of the Reverb
diffuse field. Adjust the amount to set the emphasis
between the Early Reflections and the Reverb diffuse field.
Reverb
Range: Off, -24 dB to 0 dB
The Reverb parameter sets the amount of applied
reflections from the Reverb diffuse field.